1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Identify the 2 methods to modify the routers boot sequence?

A.) Setup program

B.) Boot system commands

C.) RXBoot

D.) Config-register

Question Posted / guest


Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system ..

Answer / guest

Answer: B D

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCNA Interview Questions

Hi friend , This is Harekrushna . I have been tried for netsim keygen but i could not download this crack file .if it download then showes the writer protect error. PLEASE sugest me what isthe soluation. or any other software avalibe for pratics the network .

2 Answers   PCS,

Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

1 Answers  

What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.

1 Answers  

What does the command show access-lists 101 list? A. all defended access lists B. all access lists within the router C. the contents of standard access list 101 D. the contents of defended access list 101

1 Answers  

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

3 Answers  




'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers

2 Answers  

What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward

1 Answers  

Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A. trace B. ping C. telnet D. bootp

1 Answers  

What is the network brouter?

0 Answers  

What is the igp (interior gateway protocol)?

0 Answers  

Difference between subnetting & Vlan??

7 Answers   Cisco, TCP,

You have an IP host address of 201.222.5.121 and a subnet mask of 255.255.255.248. What is the broadcast address? A. 201.222.5.127 B. 201.222.5.120 C. 201.222.5.121 D. 201.222.5.122

1 Answers  

For more CCNA Interview Questions Click Here
Categories