Answer / amanj

copy tftp flash

Answer / guest

Answer:

Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface

2 Answers   Wipro,

---

A default route is analogous to a _________. A. default gateway B. static route C. dynamic route D. one-way route

1 Answers  

---

Which classes are assignable?

0 Answers  

---

The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments

2 Answers  

---

What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3

1 Answers  

---

---

Which command listed below sets the banner message when someone connects to the router? A.) message # B.) banner # C.) login banner # D.) description # E.) login description # F.) banner motd #

2 Answers  

---

Identify the number range for IPX SAP filters? A.) 900 - 999 B.) 1000 - 1099 C.) 800 -899 D.) 100 - 199

1 Answers  

---

What is the default encapsulation and frame type on an Ethernet interface when enabling Novell? A.) SNAP B.) Ethernet_II C.) 802.2 D.) 802.3 E.) SAP F.) Token_SNAP

1 Answers  

---

Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

4 Answers  

---

How can we configure Inter-VLAN in Layer 3 Switch? Remember one thing without Router.

7 Answers   Grace, HCL,

---

Identify the following command to configure a secret password to 'cisco'? A.) Router(config)#enable password cisco secret B.) Router(config)#enable secret cisco C.) Router(config)#enable secret password cisco D.) Router(config)#set secret = cisco

1 Answers  

---

I want to configure a serial interface on a 7500 with a VIP card. What global config command would give me access to a serial interface on a 7500? A.) int 1/0/0 B.) int s 1/0/0 C.) int s 1/1 D.) int s0.1 E.) int s1

2 Answers  

---