Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following will apply IPX sap access list 1010 for
incoming traffic, assume you are at the interface configuration?
A.) ipx input-sap-filter 1010 in
B.) ipx input-sap-filter 1010
C.) ipx access-group 1010 in
D.) ipx access-list 1010 in
- 1 Answers
- 3778 Views
- I also Faced
- E-Mail Answers
Which layer hides details of network dependent information from the higher layers by providing transparent data transfer? A.) Transport B.) Physical C.) Data Link D.) Session E.) Application F.) Network
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
You are conferring a Frame Relay router with subinterfaces on interface Serial 0 Which subinterfaces numbers could you use for this configuration? A. 1 and 2 B. 0 2 and 0 3 C. 1 0 and 1 1 D. 0 1 a and 0 1
What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN
Which cable we connect in db-9?
What does the acronym ARP stand for? A.) Address Resolution Phase B.) ARP Resolution Protocol C.) Address Resolution Protocol D.) Address Recall Protocol
Which ISDN protocol prefix specifies switching and signaling? A.) I B.) E C.) Q D.) S
What is true about frame-relay DLCI? A.) DLCI represents a single physical circuit B.) DLCI is optional in all frame-relay networks C.) DLCI identifies a logical connection between DTE devices D.) DLCI is used to tag the beginning of a frame with VLAN information
What information is provided by the local management interface (LMI)? A.) LMI encapsulation type B.) The current DLCI values C.) The status of virtual circuits D.) The global or local significance of the DLCI values
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
From Enable mode, a user types the letter 'C' and presses enter. There is more than 1 command that starts with 'C'. What message would the router return? A.) Nothing would be returned, the command is simply ignored. B.) unknown command C.) ambiguous command. D.) Copy to? E.) Configured console from console.
Identify 2 HDLC characteristics? A.) Default serial encapsulation B.) Open standard C.) Supports Stacker compression D.) Supports point-to-point and multipoint
CCNA 
