At which layer of the OSI Reference Model do bridges operate?
A.) Physcial
B.) Session
C.) Datalink
D.) Transport
E.) Network
Answers were Sorted based on User's Feedback
Answer / guest
Answer: C
Bridges and switches work at layer 2 and forward frames
based on the MAC
address.
Repeaters work at the physical layer.
Is This Answer Correct ? | 6 Yes | 2 No |
Which cable called roll-over?
What is the default switching method for the Cisco 5000 series? A.) Cut-through B.) Store-and-splice C.) Latency D.) Store-and-forward
What does a router change in a packet when it forwards a packet to the next hop? * A: Destination physical address * B: Destination network address * C: Destination network address and the destination physical address
Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash ftp D. copy tftp flash
When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop
Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route
what is secure hand shake protocol
Which statement is true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not a the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth
Does switch has the IP Address. If YES? How to find it?
Which statement is true regarding full duplex? A.) Allows for transmission and receiving of data simultaneously B.) Only works in a multipoint configuration C.) Does not affect the bandwidth D.) Allows for transmission and receiving of data but not a the same time
Explain the difference between half-duplex and full-duplex?
Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End