Answer / g3

route to a destination that is not specified in the routing table and which is outside the
local network

Answer / sonu singh

Default Route is a route that is considered to match all
destination IP address.

Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port

1 Answers  

---

ok this is practical senario question how can we comunicate two diffrent network host by i single 1603 sires of cisco router rember that the cisco series of that router have singe 100mbps ethernet now think think write all command answer is so simple i wiil; give the answer after 20 visit til then wait

2 Answers  

---

10.1.1.0 n/w advertised as /16 from EIGRP & /24 from OSPF which will come in routing table & why

6 Answers   IBM,

---

In regards to the ISDN BRI standard, which channel is used for control? A.) B B.) D C.) E D.) I E.) Q

2 Answers  

---

How the STP determinw that which Port should be Root Port, which port should be Designeted Port , Blocking Port and Forwarding Port in Layer 2 STP topology

7 Answers   Tech Mahindra, Wipro,

---

Which OSI layer performs code conversion, code formatting and encryption? A.) Physical B.) Data-Link C.) Application D.) Transport E.) Presentation F.) Network

1 Answers  

---

ccna syallabus and what is the mean by troubble shooting

2 Answers   IBM,

---

Which ISDN specification deals with call Setup and Teardown? A.) Q-Series B.) J-Series C.) I- Series D.) C- Series E.) F-Series

1 Answers  

---

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash

2 Answers  

---

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network

1 Answers  

---

Can you explain in a generic manner the packet of IPSec?

1 Answers   CCIE,

---

Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session

2 Answers  

---