I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?

0 Answers  

---

How to crimping cat cable without using crimping and any tool...........?

6 Answers   CTS, Wipro,

---

why we twist the cable in case of twisted pair cable?plz give me technical answer.

5 Answers   Infosys, NSN,

---

Q: why are switch trunking modes ( dynamic auto , dynamic desirable )used in switch while trunking? if only negotiation is the factor it can be done with one mode as well ie dynamic desirable . but why we need dynamic auto. coz it dsnt negotiates ..at all please post answer asap thanks :

2 Answers  

---

What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN

0 Answers   Infosys,

---

Value in which type of access list?

0 Answers  

---

What are the possible ways of data transmission in ccna?

0 Answers  

---

In how many ways can data be transferred in ccna?

0 Answers  

---

The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.

2 Answers  

---

Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.

1 Answers  

---

In which layer switch is work?

16 Answers   HCL, IINT,

---

Which line from a show spantree 1 command output indicates that virtual LAN 1 (VLAN1) is functioning properly? A. Root pod is FastEthernet 0/26 B. Port Ethernet 0/1 of VLAN1 is Forwarding C. Designated port is Ethernet 0/1, path cost 10 D. Designated root has priority 0 address 00D0 588F B600 E. VLAN1 is executing the IEEE compatible Spanning Tree Protocol

1 Answers  

---