What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---

Identify the command that displays ethernet0/1 interface status? A.) show interface ethernet0/1 B.) show interface ethernet e0/1 C.) show interface ethernet0.1 D.) show ethernet0/1

3 Answers  

---

2500 Value in which type of access list?

0 Answers  

---

Identify the purpose of ARP? A.) Avoiding routing loops B.) Determining a workstation's IP address C.) Sending a directed broadcast D.) Determining a workstation's MAC address

4 Answers  

---

What does the term "attenuation" mean in data communication? 1 loss of signal strength as distance increases 2 time for a signal to reach its destination 3 leakage of signals from one cable pair to another 4 strengthening of a signal by a networking device

3 Answers  

---

What is the frame relay, in which layer it comes?

0 Answers  

---

CSMA/CD stand for which of the following? A.) Carrier Sense, Multiple Access with Collision Detection B.) Collision Sense, Multiple Access with Collision Detection C.) Collision Sense, Multiple Access with Carrier Detection D.) Carrier Sense, MAC address with Collision Detection

1 Answers  

---

Tell me which cable called roll-over?

0 Answers  

---

What is the Difference between Switch and Bridge?

9 Answers  

---

take a pen and copy before solving that question there is a router name Ra there is two switch sw1 and sw2 sw1 is coneceted through fa0/1 interface of router Ra sw2 is conected through the fa1/1 serai interface of router s0/1 conected through the isp with it ip address 192.168.1.1 now therer are three host conexted through the sw1 and having ip host1=10.1.2.1 host2=10.1.2.2 host3=10.1.2.3 now there is also 3ree host conected through switch 2 i.e sw2 having ip host4=10.1.1.1 host 5=10.1.1.2 host 6=10.1.1.3 now i think u have made corect confrigation.now questios is started network admin configure the Ra router in that fassion Ra(config)#access-list 2 permit 10.1.1.0 0.0.0.255 Ra(config)#line vty 0 4 ra(config)#access-class 2 in now question is that why should network admnistratoe do it in this maneer A to give access sw1 host to acess internet B to prevent sw1 host from acessing comand promt c to prevent sw2 host from accessing console of router ra D to give sw2 host access to the enternet e prevent sw1 host from accessing internet f to prevent sw1 host from acessing the sw2 host network isp------(s0/1)..RA..(fa1/1)---SW2-host (4,5,6) | | (sw1)------host 1,2,3 this is not exect digarm but help to derive the diagram plz answer as soon as possible

6 Answers   AT&T,

---

A default route is analogous to a _________. A. default gateway B. static route C. dynamic route D. one-way route

1 Answers  

---

Using the TCP/IP protocol suite, a message is sent from host A to a destination IP address on the same LAN. How does host A determine the destination of a MAC address? A. It uses a proxy APP B. It uses APP requests C. It uses PARP requests D. It uses a router lookup table

1 Answers  

---