Answer / guest

Answer: D

For IPX access lists, the -1 is a wildcard that signifies
Any Host or

Any Network.

What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface

1 Answers  

---

Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload

1 Answers  

---

Which command displays the IP addresses assigned to specific host names? A. show hosts B. show interface C. ping host name D. config host name E. show host mapping F. show host ip address G. trace ip addresses host name H. a partridge in a pear tree

2 Answers  

---

What is the administrative distance for RIP? A.) 100 B.) 90 C.) 120 D.) 110

3 Answers  

---

Which of the following is a characteristic of a switch, but not of a repeater? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet

2 Answers  

---

What is the protocol and what is the purpose of the following address? 238 255 255 255 A. IPX a SAP broadcast B. IP a multicast group C. IP a reserved address D. IP a directed broadcast E. IPX a flooded broadcast

3 Answers  

---

Which of the following is true regarding standard ISDN BRI service? A.) ISDN BRI B channels are typically 64K. B.) ISDN BRI can handle only voice. C.) ISDN BRI can handle only data. D.) ISDN BRI has 2B and 1D channels. E.) ISDN BRI D channels are 16K. F.) ISDN BRI can handle voice and data.

2 Answers  

---

What is the virtual path?

0 Answers  

---

Which cable we connect in db-9?

0 Answers  

---

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

---

what is the difference between switch and router??

16 Answers   Infosys, Precision Techserve, Thomson,

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Router# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers   ABC,

---