Interested to Buy Any Domain ? << Click Here >> for more details...
You need to come up with a TCP/IP addressing scheme for your
company. Which two factors must you consider when you define
the subnet
mask for the network?
A.) The location of DHCP servers
B.) The volume of traffic on each subnet
C.) The number of subnets on the network
D.) The location of the default gateway
E.) The number of host IDs on each subnet
- 1 Answers
- 5122 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: C E
When determining which subnet mask to use, you must
determine how many
hosts and how many subnets are required.
| Is This Answer Correct ? | 4 Yes | 0 No |
Which of the following are Distance Vector protocols? A.) IGRP B.) RIP C.) OSFP D.) EIGRP
Which layer is responsible for providing mechanisms for multiplexing upper-layer application, session establishment, and tear down of virtual circuits? A.) Session B.) Network C.) Physical D.) Transport E.) Application F.) Presentation
Q: why are switch trunking modes ( dynamic auto , dynamic desirable )used in switch while trunking? if only negotiation is the factor it can be done with one mode as well ie dynamic desirable . but why we need dynamic auto. coz it dsnt negotiates ..at all please post answer asap thanks :
What is LSA? How many types of LSA used by OSPF version 2??
What is the command to allow you to type Tokyo instead of the IP address 172.16.30.1 to access a router named Tokyo? A.) config t, ip host Tokyo 172.16.30.1 B.) config t, ip hostname Tokyo 172.16.30.1 C.) config t, hostname Tokyo 172.16.30.1 D.) config t, ip hostname 172.16.30.1 Tokyo
IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing
Which mode called privilege mode?
What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.
What is the difference between private ip and public ip?
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
Which protocol works only on cisco routers?
Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub
CCNA 
