Answer / guest

Answer: A & C

Q: why are switch trunking modes ( dynamic auto , dynamic desirable )used in switch while trunking? if only negotiation is the factor it can be done with one mode as well ie dynamic desirable . but why we need dynamic auto. coz it dsnt negotiates ..at all please post answer asap thanks :

2 Answers  

---

A ISDN BRI circuit can be described as a which of the following? A.) 3B channels B.) 2-64Kbps B channels and 1-16Kbps D channel C.) none of the above D.) 2-64Kbps B channels and 1-16Kbps C channel

1 Answers  

---

I have one problem in my network my windows xp pc in workgroup there r 2 NIC card one I have disable in and second is active. The problem is in a day some time its ip conflict with other and when I see the event log and get the conflict ip mac and scan it with LAN scanner on one is there for that mac address nic in my network I have disable dhcp also don’t know what is the problem

8 Answers  

---

hi shyam i am putting urs question here I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

1 Answers   IBM,

---

The Datalink Layer is broken down into 2 layers, LLC and MAC. The LLC establishes media independence and what else? A.) Provides Windowing. B.) Provides flow control. C.) Provides SAP's (Service Access Points). D.) The Datalink layer does not have sublayers. E.) Provides SAP's (Service Advertising Protocol). F.) RIP Updates.

2 Answers  

---

How loops are introduced in switching? Whats the solution for that.

2 Answers   HCL,

---

What is the syntax to add a banner to the Cisco router? A.) motd banner # B.) banner C.) banner motd # D.) banner #

1 Answers   Sun Broadband,

---

What is a L2F protocol?

1 Answers   CCIE,

---

from last ten days i watched that no any new questions are placed in ccna catogarey.so plz place the questions it is very use full to beginers like us

2 Answers   HCL,

---

When using access lists, what does a Cisco router check first? A. To see if the packet is routable or bridgeable B. The destination address C. The source address D. The packet contents

1 Answers  

---

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

1 Answers  

---

Which type of switching is considered to be 'wire speed?' A.) Cut-Through B.) Multiplexed C.) Inverted D.) Layer 4 E.) Store and Forward F.) Layer 3

2 Answers  

---