Answer / guest

Answer:: A

Because the access list is numbered in the 800 range, you
are filtering

IPX/SPX traffic.

Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

1 Answers  

---

Which can be logged by IPX extended access lists? A.) source address B.) protocol C.) source socket D.) access list number E.) destination socket F.) destination address

1 Answers  

---

When we do default route?

0 Answers  

---

What is a network subnet?

0 Answers  

---

Can 2 different VTP Domain Communicate. if yes then How.

7 Answers  

---

What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II

1 Answers  

---

Define routing?

0 Answers  

---

In stp which protocol is used for detrming root port root bridge ,forwarding port and blocking port

1 Answers   IBM,

---

Can you explain IKE phases? Can you explain IKE modes?

1 Answers   CCIE,

---

You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode

10 Answers   Intel, Quark, Wipro,

---

If a router uses static routing, how does it learn the route to remote networks? The router uses a RIP request to obtain remote network numbers. The router uses a routing protocol to exchange remote network numbers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.

1 Answers  

---

As a system administrator, you need to set up one Ethernet interface on the Cisco router to allow for both sap and Novell-ether encapsulations. Which set of commands will accomplish this? A. interface ethernet 0.1 ipx encapsulation Novell-ether ipx network 9e interface ethernet 0.2 ipx network 6c B. interface ethernet 0 ipx encapsulation Novell-ether ipx network 9e interface ethernet 0 ipx encapsulation sap ipx network 6c C. interface ethernet 0.1 ipx encapsulation Novell-ether interface ethernet 0.2 ipx encapsulation sap D. interface ethernet 0.1 ipx encapsulation Novell-ether ipx network 9e interface ethernet 0.2 ipx encapsulation sap ipx network 6c

1 Answers  

---