Answer / kapilasdhir

Answer: C
LAN segmentation decreases broadcast propagation to all
segments.

Answer / shashi sinha

A

How can you add the 192.168.100.0/30 network to EIGRP without involving the 192.168.100.4/30 network as well?

6 Answers  

---

In IOS boot sequence if the flash is erased, and there is no access to TFTP server, and we can't load the partial IOS from ROM. Is there any possiblity that we can still boot the router/switch from external PC in which the IOS is installed?

6 Answers  

---

Based upon the 1st octet rule identify the range for a Class A address? A.) 1 - 126 B.) 192 - 223 C.) 128 - 191 D.) 1 - 191

1 Answers  

---

What is the attenuation?

0 Answers  

---

Identify the effect of Ctrl-Z? A.) Exits back to privileged exec mode B.) Disconnect from the router C.) Abort the ping operation D.) Exits privileged exec mode

1 Answers  

---

What is the mac address?

0 Answers  

---

Identify the type of hardware required to connect a Token ring network to an Ethernet network? A.) Repeater B.) TR-Enet C.) Router D.) Token Ring to Ethernet translation hub

1 Answers  

---

You want a message to be displayed every time someone tries to log on to the router. Which command is required to accomplish this task? A.) motd#(message)# B.) banner motd(message) C.) banner motd#(message)# D.) banner motd*(message) E.) banner login#(message)#

1 Answers  

---

What is the juncture at which the CPE ends and the local loop portion of the service begins? A. Demarc B. CO C. Local loop D. Last-mile

1 Answers  

---

How does inter- VLAN communication take place? A. It takes place through any Cisco router B. It takes place through a Cisco router that can run ISL C. It takes place through a router but this disables all the router a security and filtering functionality for the VLANS D. For nonroutable protocals (e.g. NetBeui) the router provides communications between VLAN domains E. Inter-VLAN communication is not possible because each VLAN is a separate broadcast domain

3 Answers  

---

Identify command that configures 'Cisco1' as a secret password? A.) Router(config)# enable secret password Cisco1 B.) Router(config)# enable secret cisco1 C.) Router(config)# enable password Cisco1 D.) Router(config)# enable secret Cisco1

2 Answers  

---

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classful address, no subnets C.) Enable CDP so neighbors can be detected D.) Configure all networks in Area0

1 Answers  

---