Answer / guest

Answer: A

You can only specify six name servers in one

command. The syntax is "IP name-server server-address1 [[

server-address2 ]...server-address6]. You must also enable

DNS.

Identify the prompt displayed if in privileged exec mode? A.) Router(config)# B.) Router# C.) Router> D.) Router(priv)#

2 Answers  

---

Significance of IP helper-address Command on SW? Is it necessary to put this command?

1 Answers   Accenture,

---

Why Operating System Have only 65,535 port Numbers

5 Answers  

---

in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please

4 Answers  

---

What is the function of the Application Layer in networking?

0 Answers  

---

There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton

3 Answers  

---

How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain

3 Answers  

---

hi friend i am stuck in the big problem.this problem is regading pix firewall. i have a cisco pix 515e firewall inmy company.now when i configure it and after rebooting it the ACT link never getup.when i apply clear config all comand the ACT link get up after oveservation i see that there is fauilover problem when i apply failover active ACT link agin get up is there any way to get my firewall in standby mode rember that there is only on firewall within my n/w i am lookig towards all of you jitendera kumar sinha

0 Answers  

---

Which way of communication bus topology use?

0 Answers  

---

Explain how many ways to access router?

0 Answers  

---

What are the conversion steps of data encapsulation?

0 Answers  

---

WHAT IS SERIAL TRANSMISSIONS,PARALLELL TRANSMISSION

2 Answers   ASD Lab,

---