why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
3 9480I WORKED AS A Q.C INSPECTOR IN STATIC EQUIPMENT.WHAT ARE THE QUESTIONS ARE LIKELY TO BE ASKED IN AN INTERVIEW.
9028Post New Mechanical Engineering Questions
HOW MANY PSI CAN REACH THE SCHEDULE 20,40,80 PIPES? GI,BI (CAPACITY OF PIPES)
PLESE SEND ME OLD TECHNICAL N APPTITUDE QUESTION PAPERS
What are whiskers ?
What is a process flow diagram?
Who invented the four-stroke engine?
Explain the difference between self-energizing and self-locking in brake / clutch.
How Much static pressure as per NFPA standard is required in the hydrant line?
What is the purpose of increasing the pressure on the F.O. system of the engine?
What are your significant functional achievements in the present company? How did they contribute to the total process
how long normally does the domestic refrigerant capillary tube are?
Wasco Interview 1-the type of transducer that convert mechanical movement into a voltage 2-pump 2500 psi and 100 MG select it 3-modes of heat transfer 4-the difference bet PSIA and PSIG 5-the function of relief valve and no return valve (check valve ) 6-types of bearing general catogires 7-function of bearing 8-compressor surge 9-pump cavitation 10-define critical speed 11-compression ratio decease volumetric ratio ........... 12-using inter-cooling in multi stage compressors to ....... 13-using cascade system in refrigerator function ? 14-define performance and efficiency .
Explain how to measure crank web deflection?
what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?
What is the difference between an electric motor and an electric generator?
Discuss venturimeter?