Dear Sir, Please send me the questions frequently asked during bhel persoal interview for supervisor trainee With worm regards, Alok Kumar Rout e-mail id- rjdalok22@gmail.com
1441If a cantilever beam is loaded with point load at its free end and when the load increases at which section it will break first?
5 17934Why cad cam is better field against IT field?Is the salary is good in this field and if it so then what is the average salary in this field because I don;t think that salary is good enough in this field.
1479Is cnc operating experience is must for successful career in cad/cam?How to make salary jump in this field of cad/cam?
1547Post New Mechanical Engineering Questions
hi,i am sekar.i am prepareing Assistant Motor Vehicle Inspector in TN.Transport ,if any one have previous year model pares or some questions,pls send me at gpsekar2007@gmail.com.
What is the maximum P-max for a cylinder in M/E.
Give one example each of the following proportion of materials dimensional, physical, technological and mechanical.
what are the main challenges with solar energy system?
A very strange fault i cam across today,that i never experienced not studied before, i need an answer for this. Phase to phase or line to line , L1,L2 & L3, voltages are 490VAC, but if i use line to ground , its again 490 VAC. . . whats the fault and theory behind of it?
Discuss how to prepare the M/E in the standby condition
What are the different type of mechanism to engage primary moving engine and transmission [ In other word how many different type of clutches are there
Why in screw & centrifugal compressor using rolor bearing
why constant pressure is consider for thermal diffusivity??
What is "H7014C/HQ1P4 BEARING" means ???
DIFFRENCE BETWEEN ISO AND TS
how a cyclone steam separator works?
Why is stress considered important in a shaft?
What is difference between mill and mill-drill?
What is IS standard in case of mode of measurement for ducting