Interested to Buy Any Domain ? << Click Here >> for more details...
what are the applications where bearing should not be used though it can be used(economy may be 1 of the reason)
IIT,
2162what are kinds of power stations ? what is the difference between power station and power plat?
1 2859Is expansion valve a throttle valve? why? and what is the capillary tube and the difference between it and the above ones?
5 18536Is enthalpy represent the heat content of a substance? and is the substance is liquid or gas or solid? or all
1 3556which power station plants r more efficient? which is less? which is most expensive and which is cheapest?
1906Post New Mechanical Engineering Questions
Explain how does a super charger work in a car?
What are the 3 parts in indicator diagram?
On which analysis is based the dulong’s formula for the heating value of fuel ?
sir iam vinod kumar i have done B.TECH. in mechanical engg in 2007 i want to choose career as section engg.please give the information about coaching institute.
The amount of radiation emitted per scm per sec is called …. ?
differentiate between total moisture and inherent moisture of coal.
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
Working Detail of enging?
What is the formula for 1 HP of a two-cycle engine?
If you want to provide water or any chemical @ 50 meter height how much head will you prefer for any selected pump...consider it is M.S pipings...how much friction loss will be there...show with calculation.
What is the effect of high alkaline water to a boiler?
How much should be the minimum and maximum suction and discharge pressure of screw chiller plant.
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
sir,i am golng to attend BHEL supervisor trainee personal interview on 11 sept.anyone share me that how could i perform well in interview& what they would expect from me. thank you.
What is the use of pneumatic system?
