What causes crankcase explosion?
What causes friction in the cylinder?2 2463
What do you call a piston travel from TDC to BDC?4 2964
What do you going to observe, when a diesel engine is running?
What happen when too much cylinder oil is injected in the working cylinder?
why does polytropic efficiency of a compressor decrease with increasing flow rate ?
what are the application or secification (temp/presure)for which IBR pipes should be used?
What is the difference between Over Molding and insert molding ?
diffuser increases pressure but in turbine pressure is decreasing when steam passing through casing?
hii sir. how will CAE/CFD courses useful to B.tech freshers? is this courses useful to getting job in automobile industry? plz give some advise...
What is the seal packing gland for turbine?
sir,iam applied rrb chennai for the post of junier engineer,i need objective type question book,please refer the suitable book,author and publication.
What will be the cause of the loose compression in a cylinder?
efficiency of diesel generator set:kwh x 3410 x 100/ fuel in ltrs x 0.87 x 2.2 x 19000. is it correct formula
in regenrative cycle why to use two liquid(water&mercury) on steam genration cycle.
Difference be betwin Fe-500 as per IS 226-1975 & IS 2062-2006
What type of pump is are commonly used in auxiliary boilers?
engine so2 farmula
i want sample question paper for SECTION ENGINEER IN RRB.
How the speedo meter ratio was decided for vehicle?