Interested to Buy Any Domain ? << Click Here >> for more details...
What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping
3 7719What is true about frame-relay DLCI? A.) DLCI represents a single physical circuit B.) DLCI is optional in all frame-relay networks C.) DLCI identifies a logical connection between DTE devices D.) DLCI is used to tag the beginning of a frame with VLAN information
1 6952Which frame has a Type field to identify the upper-layer protocol? A.) 802.3 B.) 802.2 C.) 802.5 D.) Ethernet_II
2 7108Which protocol will let neighbor routers know if your internetwork experienced congestion on a serial port? A.) BootP B.) IP C.) ICMP D.) ARP E.) FTP F.) RARP
1 3956What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging
3 11244The CSMA/CD Ethernet IEEE committee is defines as which of the following? A.) 802.2 B.) 802.3 C.) 802.4 D.) 802.5
1 6296How many Frame-relay encapsulation types are available with Cisco routers? A.) Four B.) Two C.) Five D.) Three
1 5973What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16
1 8143What information can you get from CDP info: (choose all that apply) A.) Hardware platform B.) One address per protocol C.) Software platform D.) Hostname E.) The same info as show version F.) Incoming/outgoing port
1 5988How does the cut-through switching technique work? A.) By using broadcast address as source addresses B.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets C.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface D.) By using a Class I repeater in a collision domain
3 8464Which of the following are Presentation Layer standards? A.) JPEG and PICT B.) MPEG and MIDI C.) ASCII and EBCDIC D.) NFS and SQL
2 13253IP standard access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) port C.) protocol D.) source address
2 6445If a frame is received at a switch and only the destination hardware address is read before the frame is forwarded, what type of switching method is this? A.) Store-and-drop B.) Latency C.) Store-and-forward D.) Cut-through
1 4528
What do you understand by redundancy?
What are the different types of the password used in securing a cisco router?
When we use loop back ip?
How does PPP use LCP for link control?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
How do you configure a cisco router for routing ipx?
What is half duplex and full duplex?
What is the difference between full duplex and half duplex?
What are the advantages of a layered model in the networking industry?
What is difference between flsm and vlsm?
What is the difference between rip and igrp?
In IPSec what is SAD, SPD and SA's?
Tell me which multicast ip eigrp protocol use?
Tell us the name of best path in eigrp protocol?
How do areas benefit a link state inter network?
