Cisco Certifications Interview Questions, Answers for Freshers and Experienced asked in various Company Job Interviews

CCNA (2231)
CCDA (90)

Cisco Certifications Interview Questions

Questions Answers Views Company eMail

Which OSI layer supports the communication component of an application? A.) Data-Link B.) Physical C.) Session D.) Presentation E.) Application F.) Transport

2 7639

Identify the length of an IPX address and it's components? A.) 80 bits, 48 bits network and 32 bits node B.) 32 bits, 16 bits network and 16 bits node C.) None of the above D.) 80 bits, 32 bits network and 48 bits node

1 4096

Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

3 6272

Which OSI layer incorporates the MAC address and the LLC? A.) Data link B.) Network C.) Physcial D.) Transport

4 10844

If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI

1 6796

Identify the 2 characteristics that TCP and UDP share in common? A.) Both use port numbers to identify upper level applications B.) Operate at the Network layer C.) Both are Transport protocols D.) Both are reliable communications

3 11526

Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance

1 4741

Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub

2 4780

Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises

1 4363

Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verifies connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured

1 6450

Identify the 3 characteristics of IPX RIP? A.) Distance vector B.) Does not support multiple paths C.) 60 second updates D.) Default encapsulation is SAP E.) Uses ticks and hop count as a metric

2 5446

Identify the access-list range for an extended IP access-list? A.) 800 - 899 B.) 1 - 99 C.) 1000 - 1099 D.) 100 - 199

1 3827

Identify the X.25 addressing standard? A.) X.121 B.) X.25a C.) ITU-1 D.) Q933a

1 4013

Identify 3 features of IGRP? A.) Composite metric B.) New horizon C.) Flash (triggered) updates D.) 60-second periodic updates E.) Poison reverse

1 3873

Where is the backup configuration file stored? A.) RAM B.) ROM C.) Console D.) NVRAM

1 4840

Un-Answered Questions { Cisco Certifications }

Explain types of communication in ipv4?

1074

Explian what is a node?

1082

Explain how many ways to access router?

1176

Explain what is eigrp?

1037

which points are eliminated by the DBSCAN algorithm?

2041

Explain on which interface we always apply access-list?

1058

How does cut-through LAN switching work?

1181

What is the minimum and maximum request timer?

1185

What do you understand by poe (power over ethernet)?

1135

How many ports are present in a router?

1187

What is matric?

1037

Which cable we connect in db-9?

1075

How we can see mac address from dos prompt?

1064

What is EIGRP?

1144

Which mode called privilege mode?

1081

For More Un-Answered { Cisco Certifications } Questions Click Here