what r the parts calibrated in gc
- 21 Answers
- 32540 Views
- ELBS, Reddy Labs, I also Faced
- E-Mail Answers
Answer Posted / surya
Flow rate , Oven , Auto injector , Detector response , HS
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Please give idea about method development for cleaning method and how maco level establish
if instrument calibration fails then what require to do?
Why do we use KMnO4 in the test of control of obsorbance ? and why do we take specific quantity i.e 57-63mg?
how you establish the LOQ?
how can I make the copper get white bye any salt or acit?
How do we quantify crystaline and amarpous forms by using (NMR, XRD)spectroscopic techniques? Which any others instruments are useful for this quantification? explain
While performing TOC sst analysis Zero shift disabled & sample analysis zero shift enabled why?
How much is the standard area for glc analysis
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
How can I develope method of dissolution by HPLC OR UV
in OSD forms require to use gas chromatography?
why we use a particular hplc column for a particular compound give reasons?please
What is the purpose of octyl silane columns?
what is the extinction coefficient for Indomethacin or at 319nm wave length.
How to know the estimated LOQ concentration in ppm
