Client traffic is being bridged trough LAN interfaces on two
WLCs.Which roaming option will Keep
them on the same IP Subnet ?
Answers were Sorted based on User's Feedback
Answer / moparthynani
A. Layer 1 intercontroller roaming
B. Layer 2 intercontroller roaming
C. layer 3 intercontroller roaming
Is This Answer Correct ? | 1 Yes | 0 No |
Which of the following three protocols replace SDLC? A. 802.2 B. HDLC C. QLLC D. X.25
What are two ways to connect a PC to a LAN when using ATM (Asynchronous Transfer Mode)? A. ATM endpoint B. ATM LAPB C. ATM router D. ATM switch
What would a TE2 device be used for in an ISDN connection? A. as a connection from an NT1 device to an NT2 device B. as a connection from a non-ISDN terminal through a TA to the ISDN network C. as a connection from four-wire subscriber wiring to the conventional two-wire local loop D. as a connection to the ISDN network through a four-wire, twisted-pair digital link
What is the standard ethernet cabling specification? (not IEEE 802.3) A. STP B. Coax (thin) C. Coax (thick) D. UTP
Which of the following are true regarding switched virtual circuits (SVCs) and permanent virtual circuits (PVCs)? Choose two. A. SVCs and PVCs can use the same circuit. B. PVCs are permanently established virtual circuits. C. SVCs and PVCs terminate the circuit when data transmission is complete. D. SVCs are virtual circuits that are dynamically established on demand and terminated when data transmission is complete.
Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.
What is the second step when creating a prototype? A. Develop a test plan B. Review the customer requirements C. Investigate what the competition will be proposing D. Define how big the prototype will be
What are three LAPB features supported by SDLC? A. Frame types B. Frame format C. Field functions D. ABM
What type of address is analyzed by a Layer 2 switch? A. network address B. MAC and network address C. Protocol type, MAC, and network address D. MAC address
What protocol advertises Netware services to network clients? (Type acronym).
Distance Vector and Link-State protocols converge more quickly if: A. there is router redundancy B. there is router redistribution C. the update interval is set to its maximum D. the whole routing table is sent to announce changes
When doing an RFP (Request for Purchase) for a customer, at what step do you reiterate your solution and the customer requirements? A. Design Requirements B. Design Solution C. Summary D. Appendices