Interested to Buy Any Domain ? << Click Here >> for more details...
Regarding a full-mesh network and a partial-mesh network,
what is the most accurate statement?
A. Split Horizon will not work on a full-mesh network
B. A full-mesh network is more expensive because more
routers are used
C. A partial-mesh network is less expensive because less
virtual circuits are used
D. Broadcasts are more plentiful on a partial-mesh network
- 1 Answers
- 5265 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: C
A partial-mesh network is less expensive because less
virtual circuits are used. On a full-mesh network, you must
have either a physical or a virtual circuit between all the
nodes. This provides excellent redundancy, but is very costly.
| Is This Answer Correct ? | 1 Yes | 1 No |
difference between layer 3 switch and router
0 Answers Aptron, Tech Mahindra,
Traffic Shaping does which one of the following? A. Eliminates bottlenecks by throttling back traffic volume at the source or outbound end B. Reduces the frame size so bandwidth is better utilized C. It increases source traffic to a configured bit rate D. Allows you to control hubs and repeaters
OSPF supports priority routing for which TCP/IP feature? A. PA B. TCP C. IP D. SNA
Match the following routing protocols with their routing algorithm. A. OSPF 1. Distance Vector B. IGRP 2. Link-State C. RIP D. IS-IS E. NLSP F. RTMP G. AURP H. BGP
When should you apply SAP filters to Netware service advertisement messages? A. When services are not required for a particular area or network B. Only after service advertisement messages have flooded the network C. Before any type of router convergence takes place D. When no change in network services has taken place for 40 minutes
What layer of the OSI reference model does TCP reside in? A. Session B. Transport C. Network D. Data-Link
5. Which Two Settings must be configured in order to use the GUI to configure Call Admission Control with voice Applications
When characterizing a network, how many buffer misses should not be exceeded on a Cisco router per hour? A. 10 B. 25 C. 50 D. 100
What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer
What are the three commonly used methods of flow control used for handling network congestion? A. Buffering B. Source-quench messages C. Error checking D. Windowing
What AppleTalk protocol permits AppleTalk workstations to share files across a network?
What category or categories does Client/Server fit into the following Job Aid? Name of Protocol Type of Protocol # of Users # of Hosts or Servers Comments
CCNA 
