You want to assign IP addresses to a large number of
workstations. What is the best way to do this?

A. Cisco Network Registrar

B. Cisco IOS NAT Feature

C. Assign them static IP addresses

D. Let the workstation assign its own IP address



You want to assign IP addresses to a large number of workstations. What is the best way to do this?..

Answer / guest

Answer: A

Cisco Network Registrar (CNR) is a full-featured DNS/DHCP
system that provides scalable naming and addressing services
for enterprise and service provider networks.

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCDA Interview Questions

What are the three commonly used methods of flow control used for handling network congestion? A. Buffering B. Source-quench messages C. Error checking D. Windowing

1 Answers   Cisco,


how many default route can be configure on a router

3 Answers  


difference between layer 3 switch and router

0 Answers   Aptron, Tech Mahindra,


What network design is becoming common when there is a central office with one or more remote locations? A. ISDN PRI at the central location and ISDN BRI at the remote locations. B. Using core routers at all sites C. Only using access routers D. Using a full mesh network

1 Answers  


What is not a function of the distribution layer? A. Routing between VLANs B. Implement tools such as access lists, packet filtering, and queuing C. Implement security and network policies D. Provide workgroup/user access to the network

1 Answers  






In which category should Frame Relay be placed within the following Job Aid? Name of Protocol Type of Protocol # of Users # of Hosts or Servers Comments

1 Answers  


EIGRP was developed to improve what two protocols? A. OSPF B. RIP C. BGP D. IGRP

7 Answers  


Which of the following three sets of IP addresses and subnet masks are private IP addresses? A. 10.0.0.0 255.0.0.0 B. 172.16.0.0 255.255.0.0 C. 172.16.0.0 255.240.0.0 D. 192.168.0.0 255.255.0.0

1 Answers  


What PPP frame initiates the network layer protocols to be used during a connection?

1 Answers  


Which router would you choose for your design? A. 1600 B. 1700 C. 3600 D. 3640 E. 7200

1 Answers  


When designing a flat switched network you can have: A. the same number of IP and IPX nodes without performance degradation B. more IP than IPX nodes on the same segment C. more IPX than IP nodes on the same segment D. more AppleTalk than IP nodes on the same segment

1 Answers  


What are the five areas of the ISO Network Management Model? A. Performance management B. Accounting management C. Flow management D. Configuration management E. Operating management F. Fault management G. Routing management H. Security management

2 Answers  


Categories