Return address will be returned by function to
- 2 Answers
- 6171 Views
- Wipro, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / binti-islam
Return address from a subroutine program is popped out and put in program counter .
When the Call instruction comes into main program , the contents of PC are pushed to stack.
| Is This Answer Correct ? | 0 Yes | 0 No |
What is baud rate?
Name the pin in 8086 microprocessor that is used for selecting mode of operation?
Suppose you have a combinational circuit between two registers driven by a clock. What will you do if the delay of the combinational circuit is greater than your clock signal?
Introduction of 8051 microcontroller architecture?
What type of architecture is used in 8085 microprocessor?
What is the difference detween ISR & function call
17 Answers Bosch, General Motors GM, Infosys, Wipro,
What are set up time & hold time constraints What do they signify Which one is critical for estimating maximum clock frequency of a circuit?
What is an interrupt service routine in microcontroller?
What happens when the intr signal goes high in the 8085?
What is the purpose of the ale pin?
What are the steps involved in a fetch cycle
What is address bus, data bus and control bus in microprocessor 8051 ?
86 Family 
