How are data passed from jcl parm to assembler program?
No Answer is Posted For this Question
Be the First to Post Answer
What does LA R3,R3 ?
HOW MANY MAXIMUM BASE REGISTERS WE CAN HAVE IN A PROGRAM AND ALSO HOW MANY MAXIMUM BASE REGISTERS WE CAN HAVE IN A SINGLE PROGRAM.
What is need of start 0? In steed of can we use anyother numerics? If we use what will happen?
what is need of start 0? In steed of
How are data passed from jcl parm to assembler program?
Write the fetch cycle and execute cycle for following instructions:JMPNZ (jump to the given address if the accumulator not equal to zero) RET(return from a subroutine) ADB (add the contents of register B to the accumulator and save result in the accumulator).
In the house keeping section of an MVS assembly language program, like the one below STM R14,R12,12(R13) BASR R12,R0 USING *,R12,R11 LA R11,2048 LA R11,2048(R11,R12) .... .... 1. What if BASR R12,R0 IS NOT PRECEDE USING *,R12,R11? 2. USING (base address), REGISTER does USING directive says assembler to treat particular Register as a base register with the mentioned base address..in the above case * i.e current location counter..well if that is the case why we need BASR R12,R0 ? 3. What if I write like STM R14,R12,12(R13) BASR R12,R0 LA R11,2048 LA R11,2048(R11,R12) USING *,R12,R11 there is no address resolution being calculated in both LA statements so is it a right way to set Base register?..will there be any issues with Domain regarding R11 and R12?
how to produce SOC7 abend
What is maximum displacement and how to cross this limit?
Explain how to produce soc7 abend?
Is it possible to access some memory location (Ex: VAR1 DS P) without using Base Displacement?
How do you round the addition or subtraction of two numbers in assembler?