What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Annex D B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) Anex A

2 Answers  

---

What must be true for two routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D.) Configured for PPP

1 Answers  

---

What is wide-mouth frog?

4 Answers   Wipro,

---

Which global configuration command will tell the router to load the IOS file 'IOS_filename' from the Network File server at 1.2.3.4 during the next boot? A.) boot system flash IOS_filename 1.2.3.4 B.) boot system tftp IOS_filename 1.2.3.4 C.) config-register 0x0 1.2.3.4 D.) boot system rom 1.2.3.4 E.) This can not be done, only the first file in flash can be used.

1 Answers  

---

State the difference between dynamic IP and static IP addressing?

0 Answers  

---

Hub in star topology or bus topology?

0 Answers  

---

Utilizing RIP, what is the limit when it comes to number of hops?

0 Answers  

---

Explain the difference between routable and non- routable protocols?

0 Answers  

---

What command would you use to find out the names of Novell servers on a network? A. show ipx servers B. show ipx hosts C. show ipx sap D. show ipx nodes.

1 Answers  

---

How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds

2 Answers  

---

The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'

1 Answers  

---

Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains

1 Answers  

---