What is the default LMI type? A.) Cisco B.) ANSI C.) IETF D.) Q933a

3 Answers  

---

Explain the difference between routable and non- routable protocols?

0 Answers  

---

Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells

1 Answers  

---

Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

1 Answers  

---

what is ping utility and how to work.

3 Answers   Cisco,

---

Hello Mr.Jitendera Kuamr Sinha, how is every thing going on? Thanks for your reply. Dear Friend if you can Explain it little bit deeper i will be realy thanks full. Wish you all the Best.

1 Answers  

---

What is the command to copy the IOS image to a TFTP server? A.) copy flash tftp B.) copy running-config tftp C.) copy ios tftp D.) copy startup-config tftp

2 Answers  

---

How many types of ospf configuration?

0 Answers  

---

How the STP determinw that which Port should be Root Port, which port should be Designeted Port , Blocking Port and Forwarding Port in Layer 2 STP topology

7 Answers   Tech Mahindra, Wipro,

---

Which three statements about common elements of the TCP/IP protocol stack are true? (Choose three) A. IP provides connectionless service and routing capabilities B. APP enables devices to locate the IP address of local devices C. UDP provides simple connectionless service without windowing or acknowledgments D. ICMP provides connection oriented management data to routers and Layer 3 switches E. TCP enables devices to send large quantities of data using windowing in a connection oriented manner

2 Answers  

---

What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase

2 Answers  

---

Which two statements about IP RIP are true? (Choose two) A. It limits hop counts to 31 B. It is a link state routing protocol C. It uses autonomous system numbers D. It is capable of load sharing over multiple paths E. It uses bandwidth as the metric for path selection F. It broadcasts updates every 30 seconds by default

1 Answers  

---