Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

1 Answers  

---

Identify the command to configure the router to boot from an IOS located on a TFTP server? A.) boot system tftp IOS.exe 172.16.5.1 B.) boot system tftp 172.16.5.1 IOS.exe C.) boot system flash tftp 172.16.5.1 D.) boot system IOS.exe 172.16.5.1

2 Answers   HCL,

---

Mention what does data packets consist of?

0 Answers  

---

Which cable called v.35?

0 Answers  

---

what are the different symmetric algorithms?

0 Answers   CCIE,

---

whats the routing protocol supporting in both juniper , cisco routers.

10 Answers   HCL,

---

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#

1 Answers  

---

Which two describe frame tagging? A.) Examines particular info about each frame B.) A unique ID placed in the header of each frame as it traverses the switch fabric C.) A user- assigned ID defined to each frame D.) The building of filter tables

1 Answers  

---

Can 2 different VTP Domain Communicate. if yes then How.

7 Answers  

---

Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  

---

What is a vlan?

0 Answers  

---

Tell me why we use filter option?

0 Answers  

---