Interested to Buy Any Domain ? << Click Here >> for more details...
What is the default LMI type?
A.) Cisco
B.) ANSI
C.) IETF
D.) Q933a
- 3 Answers
- 9420 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / jatin
Ans : A, B, D
Cisco, ansi, and q933a are the LMI types. Cisco is the
default. The LMI type Cisco is Cisco-proprietary, and it's
recommended that in an all-Cisco environment, you use this
LMI type.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / dannoh
A, C, D;
From 2008 Cisco Press ICND2 book: "Three LMI protocol
options are available in Cisco IOS software: Cisco ITU
(Q.933-A) and ANSI...Configuring LMI type is easy.
Thoday's most popular option is to use the default LMI
setting. This setting uses the LMI autosense feature..."
| Is This Answer Correct ? | 3 Yes | 0 No |
What is the Difference between Hub and Switch?
Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two commmands should you use to show the routers that are reachable? (Choose two) A. show ip map B. show ip router C. show frame-relay map D. debug frame-relay map
How convergence happen in ospf?
How Bridge Protocol Data Unit detect looping in Network? How Bridge Protocol Data Unit work? explain?
What does the acronym ARP stand for? A.) Address Resolution Phase B.) ARP Resolution Protocol C.) Address Resolution Protocol D.) Address Recall Protocol
Explain types of communication in ipv4?
If i had 400 computers set in a site how many VLAN i should configure so that i can share a proper bandwith,and also i had two lease line connection of 2Mbps each,
How do you disable advanced editing? A.) terminal editing B.) terminal no editing C.) disable editing D.) no terminal editing
Why we used Virtual MAC in GLBP
Identify the command that disables name-to-address translation? A.) Router(config-dns)# no ip domain-lookup B.) Router(config)# no address translation C.) Router(config)# no ip domain-lookup D.) Router(config)# ip domain-lookup
Which router command allows you to view the entire contents of all access lists? A. Router# show interface B. Router> show ip interface C. Router# show access-list D. Router> show all access-list
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
CCNA 
