Answer / guest

Answer: C

LMI offers extensions for managing complex internetworks
that allow internetworking devices to communicate easily
with a Frame relay network.

You want to assign IP addresses to a large number of workstations. What is the best way to do this? A. Cisco Network Registrar B. Cisco IOS NAT Feature C. Assign them static IP addresses D. Let the workstation assign its own IP address

1 Answers  

---

how many default route can be configure on a router

3 Answers  

---

What are two services that the OSPF Hello protocol provides? A. It discovers neighbor routers B. It gets routes from neighbors during startup C. It helps elect a designated router D. It allows administrator to test for connectivity between two devices

1 Answers  

---

Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.

1 Answers  

---

What happens to performance if the maximum MTU (Maximum Transmission Unit) size is used? A. Performance increases B. Performance decreases C. Performance stays the same D. Performance has nothing to do with the MTU

1 Answers  

---

What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay

1 Answers  

---

difference between layer 3 switch and router

0 Answers   Aptron, Tech Mahindra,

---

What are the five areas of the ISO Network Management Model? A. Performance management B. Accounting management C. Flow management D. Configuration management E. Operating management F. Fault management G. Routing management H. Security management

2 Answers  

---

What happens when the hold-down timer expires? A. Routes are flushed from the routing table after the flush timer expires B. Routes are flushed from the routing table immediately C. Routes are never flushed D. A triggered update will reset the hold-down timer

1 Answers  

---

When doing an RFP (Request for Purchase) for a customer, at what step do you reiterate your solution and the customer requirements? A. Design Requirements B. Design Solution C. Summary D. Appendices

1 Answers  

---

What set of Frame Relay enhancements offer extensions for managing complex internetworks? A. CMT B. SNMP C. LMI D. RMON

1 Answers  

---

What is an advantage of CHAP over PAP? A. Passwords are stored on separate servers in encrypted form B. CHAP sends passwords unencrypted to save connection time C. CHAP does not attempt to verify whether the user is authorized to access the requested resource D. ID?s and passwords are automatically stored in cache

1 Answers  

---