Identify the default values that make up IGRP's composite
metric?
A.) Bandwidth
B.) Load
C.) Reliability
D.) MTU
E.) Delay
Answer / guest
Answer: A E
IGRP can be configured to use all 5 within it's metric. By
default it
uses bandwidth and delay.
Is This Answer Correct ? | 4 Yes | 0 No |
Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classful address, no subnets C.) Enable CDP so neighbors can be detected D.) Configure all networks in Area0
What is Spanning Tree Protocol and how it work? I know it is - STP is Spanning tree Protocol. It Stops the looping in the network? How STP work? How it stop Looping in network?
What is the UDP datagram format? A. Source Port - 16 bits, Destination Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data B. Destination Port - 16 bits, Source Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data C. Source Port - 16 bits, Destination Port - 16 bits, Checksum - 16 Bits, Length - 16 bits, Data D. Source Port - 8 bits, Destination Port - 8 bits, Length -8 Bits, Checksum - 8 bits, Data
wat is last assignable host address in 209.165.201.0/27 network?
After how long ospf exchange its topology table?
Which command will display Ethernet 0's IP address? A.) display ip address e0 B.) show ip interface e0 C.) show address e0 D.) sh ip address e0 E.) show all
Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash
IP standard access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) port C.) protocol D.) source address
What is an advantage of local area network (LAN) segmentation? A. smaller collision domains B. elimination of broadcasts C. decreased cost of implementation D. larger number of users within the same domain
Explain how many broadcast domains are in switch?
Suppose we are having two router i.e. Router1 and Router 2 connected with each other on Serial Link,Router Network having ip 192.168.1.0/24. 1> which ip is used at router1 and router2 interface? 2>Which Command is used to assign ip to router1 and router2 interface?
Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended