Which statements are true regarding half duplex?
A.) Only works in a point-to-point configuration
B.) Allows for transmitting and receiving but not at the
same time
C.) Allow for transmitting and receiving of data simultaneously
D.) Doubles the bandwidth
Answers were Sorted based on User's Feedback
Answer / madhukar
B.) Allows for transmitting and receiving but not at the
same tim
Is This Answer Correct ? | 3 Yes | 0 No |
Hi all, Kindly can you tell me what is demand ccna voice in field and what is profile of ccna voice.so pl very urgent bcz i am going to join institute
HI I am Rajveersinh. I am Leaving in Ahmedabad-gujarat. I am Hardware & Networking Stundent In JETKING. my Intersted in CICKO Side. Please send ME totel detail in CICKO surtifiction my E-mail ID IS as_raj@ymail.com
Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0
Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup
'Show cdp neighbors detail' show the following 3 pieces of information? A.) Hardware platform B.) Software version C.) Same as 'show version' command D.) Up to 1 address for each protocol E.) Non-direct connected routers
Explain the types of resource sharing?
Which EXEC command displays system hardwarde configuration information software version and the names and sources of configuration files and boot images on a router? A. show boot B. show flash C. show config D. show version
Identify 3 IP routing protocols? A.) RIP B.) AURP C.) OSPF D.) IGRP E.) ARP F.) ICMP
Which command we give for live view of remote site routers?
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
What is the default encapsulation and frame type on an Ethernet interface when enabling Novell? A.) SNAP B.) Ethernet_II C.) 802.2 D.) 802.3 E.) SAP F.) Novell-ether
IPX traffic using different encapsulation types can go over the same data link A. True B. False