What will be cross section area of copper conductor for carry 2000 amps & 2500 amps....sq.mm.?/
3 6184Generally In transformer Tap Changer on HT side, but I have seen in 66KV side in 220/66 KV, 100 MVA, Areva make transformer. Why ?
7 9395What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
1474what is the difference between potential Transformers and capacitive voltage transfoemers and where it is used?
5 11809Post New Electrical Engineering Questions
what is the purpose of silicon dropper used in battery charger?
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
What is mason's gain formula?
can we use engine degreaser for electrical motors?
What is the unit audit? if our Max demand is something and we found much more unit then how to improve our max demand?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
how to setting voltage RTCC panel
previous year paper of ntpc bhel for degree in electrical enng
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
why the field winding in dc motor is not short circuited eventhough dc supply is applied across the winding