hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
IIT,
1844What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
2198Meaning of CTPT ,how it works &how it measures the reading on trivecter meter,&what is trivecter meter
1 35262How do you protect your appliances from harm in case of neutral failure in a three phase power supply set up.
4 8099Post New Electrical Engineering Questions
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
how to decide choke rating for drive?
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
iam preparing for rrb section engineer post in electrical branch.suggest the right textbook for my reference.fromwhere i will get the previous q.papers?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
what are the specifications we must look at to select a relay for any capacity motor?
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
Why need 3phase machine double earthing?
What are safety device in vcb and acb?
What is a difference between indoor transformer and outdoor transformer of same rating
What is the difference between diode and a transistor in terms of the direction of current flow?
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
WHAT IS DEAD END IN PROTECTION?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]