how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
2002What are all the type of vibration measurement measuring in turbine, what is the output of vibration sensor.
3 6105How we are deciding while programming in pid controller , What we are using heating or cooling.
1 3525Post New Instrumentation Questions
How to check vortex flow meter is in good condition while we do not having calibration setup?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
what is the difference between attemperator and desuperheater ?
Calibration procedure for electro magnetic flow meter
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
What is cut off relay? And why use in PLC and DCS?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is ultrasonic flowmeter?
What are the interlocks we have to check during the start up of LP/HP compressor?
Explain how thw analog to digital converter works with the circuit diagram
Why trim span ? How?
Explain about the leakage class of the control valves
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
How to calibration a control valve?
Identification of ss fittings, pilot valves, relief valve.
