Interested to Buy Any Domain ? << Click Here >> for more details...
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
1377Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75
The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is:
WARNING: Could not connect to equalize destination. (7001)
Retrying. Number of retries = 0/1
ERROR: LdXopsLoadMain: connect error 10060
ERROR: Processing terminated due to connection error. (7002)
Equalization end with errors. STN0149
---- ERROR = 2 WARNING = 1 ----
Background:
>Updated the ExaOPC software on the STN from 3.60 to 3.75
>STN operating system is Windows Server 2008 R2
>HIS operating system is Windows Server 2016 Stanard
Solutions attempted include:
>Ensuring all IP addresses are correct and all networked devices can be pinged.
>The ability to ping a device using its host name from another device (
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
2497how will you segregate the alarm levels in alarm management system during factory Acceptance Test
2386Post New Instrumentation Questions
this site is owned by an nonsense
Linear amplifier.
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
How RAL(Rotary air lock)works in cement industry?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
which type inter lock use in petrochemical refinery,and oil & gas?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
Explain the working of rota meter.
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
What are primary elements of measuring pressure?
which type of signal used in instrument?
