What is the rating of your capacitor bank at your company.
- 36 Answers
- 75435 Views
- Ajnara Group, Amara Raja, Amol Electricals, Apollo, ATC, Bhagiradha Chemicals & Industries, Bharat, CBRE, Cisco, Government, JLL, MEIL, Reliance, Sterling, TNEB Tamil Nadu Electricity Board, Torrent Pharma, Victory, I also Faced
- E-Mail Answers
Answer Posted / prashanth kumar
6300kvar & 2100kvar 11kv
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
How can we convert 11 kv to 440 volt without using transformer ?
What is dynamo?How it works and what is the function of dynamo in a DG.
USE OF 8 WAY PAN ASSEMBLY
What are the disadvantages of autotransformer?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
what work will do diffrential realay DG set
How to know vacuum in vacuum cylinder of breaker in working condition
What is the fault or needs to be done when frequency in ac drives is not changing?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
what is the role and fuction of automatic transfer switch in rotary ups
What are high pass filter and low pass filter? and What are the flowmeter ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
What are the advantages of thermal power plant?
