Interested to Buy Any Domain ? << Click Here >> for more details...
Topic :: Watt
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
1936an amazing situation was faced when an alive distribution panel with 415 volts and carrying almost 200Amps has become short and this metal cubical showing 220 volts against neutral and earth. to redress any confusion i checked the panel with help of single 200watts test lamp which also glowing with max.intensity b/w neutral & metal body of DB. amazing situation is that i hold the DB firmly more than once with necked foot means without insulated shoes but not received any electrical shock. whereas our all running gen sets neutral points also proper grounded and this short DB was completely earthed , this is beyond my understanding . any body explain how is it possible . our running gen set neutral also grounded firmly
1 2351Why we use two wattmeter during block rotor test and no load test of 3phase induction motor? And how can we understand the neat power requirement of from this test?
2 10615when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
1932a 120 60 watt incandescent lamp has to be operated from 50 c/sec 1 phase ac supply. in order to do this a circuit element has to be connect in series with the lamp. which one of the following sries element is preferable.
SSC,
1 3873I want to build 100 megawatt hydel dam. What does mean, 100 MW per hour? then how many electric bulb of 100 Watts the dam would lit?
1 6776how to calculate unit consumption on 3phase 380-415 v0lt kilowatt motor eg ( 55kw,380v,3phase 50-60hz)
1 3742
what about the power of wattmeter at starting and loding?
How can I calculate the Mega watts required to run a plant having many electric motors and other electrical components.
How can we checked Killo Watts of Motor & Alternator?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
i want use the cable size 16cx4 core aluminium usege watts 240x2000w this cable size is correct?
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
A signal with 300 milliwatts power passes through 10 devices, each with an average noise of 3 microwatts. What is the SNR? What is the SNRdb?
How to calculate IKW (inputkilowatt) ie.. efficiency of a airconditioning chiller plant capacity of 310TR
how much power is required for a 200 watts bulb if 60p/unit is observed?
what is difference b/w watt loss and watt full devices. what is watt loss and watt full devices?
What is principle of Floroscent tube 36watt.
