Interested to Buy Any Domain ? << Click Here >> for more details...
Topic :: Insulation
what is the heat insulation material is adaptable for a flue gas duct that carries waste heat from brick kiln to brick drier and what temperature is required to maintain at the tunnel to dry adobe bricks adequately
1645To determine the Healthiness of Insulation we will be performing Dielectric tests i.e Insulation Resistance test, Partial Discharge test,Switching Impulse, Lightning impulse, Tan Delta test ...etc why we required to perform this many test, why cant we do only one test. for Transformer, CT's
1 3653how we can do the insulation on secondary of ct explain and so that tan delta will within limit
19301) Can anyone give me a typical value for Insulation Resistance of 11kV xlpe cable? 2) How much will the IR value decrease per KM of cable length added?
1 3972what is the rating of Insulation tester for measure 15 KW, 3 phase 415V 50 HZ induction motor?
ABB,
2 6081
What is the meaning of Insulation H for transformers????
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
does any one know where we can purchase insulation oil for high voltage oil filled cables
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
what are the basic insulation levels & what its Unit
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
ho can we calculate the conductor insulation value according to their ratings like voltage,current etc.how insulation value related with voltage,current and power of amachine
Which Class insulation is prefered for the sandwich Busducts ? Why?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
how can motor both beasrings insulation resistance can be check?
what is program data insulation in dbms?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
