write a c program to convert fahrenheit to celsius?

TCS,

At which temperature in deg Celsius Asphalt is used for the pavement of Roads?

write a program that will read the temperature in Celsius and convert that into Fahrenheit.

at -10 degree Celsius how can i sell an refrigerator

what is xcelsius architecture?

Zensar,

PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear

MSL, SRAAC,

What are the advantages of Xcelsius & Crystal reports over Infoview?

Reliance,

The water is superheated steam at 440 degree Celsius and 17.32 megapascals. Estimate the enthalpy of the steam above. From the steam table for water at 440 degree Celsius, enthalpy of steam, h at 18 megapascals is 3103.7 kilojoules per kilogram and at 16 megapascal is 3062.8 kilojoules per kilogram. Assume that h = mP c where P is pressure; m and c are constants at fixed temperature with small differences in P.

Calculate the cooling duty, H required to condense and cool acetone from 100 degree Celsius to 25 degree Celsius at atmospheric pressure. The heat of vaporization for acetone at its normal boiling point is 30.2 kJ / mol. The boiling point of acetone at atmospheric pressure is 56 degree Celsius. The flowrate of acetone through the condenser is 100 mol / s = N. Value of sensible heat needed to increase the temperature of acetone in liquid form from 25 to 56 degree Celsius is 4.06 kJ / mol. Value of sensible heat needed to increase the temperature of acetone in vapor form from 56 to 100 degree Celsius is 3.82 kJ / mol. Unit of H is kJ / s.

A 1.5 weight % aqueous salt solution is concentrated to 4 weight % in a single-effect evaporator. The feed rate to the evaporator is F = 7500 kg / h and the feed is at 85 degree Celsius. The evaporator operates at 1 bar. By assuming that only pure solvent of water exists in the form of vapor from the feed, calculate the flow rate of such vapor V.

A concentric, counter-current heat exchanger is used to cool lubricating oil. Water is used as the coolant. The mass flow rate of oil into the heat exchanger is 0.1 kg / s = FO. For oil, the inlet temperature TIO = 100 degree Celsius and the outlet temperature TOO = 55 degree Celsius. For water, the inlet temperature TIW = 35 degree Celsius and the outlet temperature TOW = 42 degree Celsius. What is the mass flow rate of water in kg / s, FW needed to maintain these operating conditions? Constant for heat capacity of oil is CO = 2131 J /(kg K) and for water is CW = 4178 J /(kg K). Use the equation (FO)(CO)(TIO – TOO) = (FW)(CW)(TOW – TIW).

At 150 degree Celsius, a mixture of 40 wt % Sn and 60 wt % Pb present, forming phases of alpha and beta. Chemical composition of Sn at each phase : CO (overall) : 40 %, CA (alpha) : 11 %, CB (beta) : 99 %. (a) State 2 reasons for the existences of alpha and beta phases for the mixture of Sn – Pb at 150 degree Celsius. (b) By using Lever Rule, calculate the weight fraction of each phase for alpha, WA = Q / (P Q) and beta, WB = P / (P Q) where Q = CB – CO and P = CO – CA.

Question 31 – For liquid benzene, the CP constants are : a = 129440, b = - 169.5, c = 0.64781. Reference temperature is 298 K. The temperature of benzene is 60 degree Celsius. Calculate the enthalpy of benzene by using the formula H = a (DT) + (b/2) (T^2 – TREF^2) + (c/3) (T^3 – TREF^3) where ^ is power, DT is temperature difference with TREF = 298 K. H is in J / kmol. DT = T – TREF.

Question 37 - Calculate the bubble temperature T at P = 85-kPa for a binary liquid with x(1) = 0.4. The liquid solution is ideal. The saturation pressures are Psat(1) = exp [ 14.3 - 2945 / (T + 224) ], Psat(2) = exp [ 14.2 - 2943 / (T + 209) ] where T is in degree Celsius. Please take note that x(1) + x(2) = 1. Please take note that y(1) + y(2) = 1, y(1) = [ x(1) * Psat(1) ] / P, y(2) = [ x(2) * Psat(2) ] / P, * is multiplication. P is in kPa.

Question 41 - According to Raoult's law, the pressure when vapor is completely condensed, P = x(1) P(1) + x(2) P(2) ... + x(n) P(n) when x(1), x(2) ... x(n) are the mole fractions of component 1, 2 ... n and P(1), P(2) ... P(n) are the vapor pressures of component 1, 2 ... n. A vapor at 74 degree Celsius containing 70 mole % water and 30 mole % ethanol is to be completely condensed. At the temperature of 74 degree Celsius vapor pressure is 0.38 atm for water and 0.97 atm for ethanol. What is the minimum pressure the compressor must be operated?