What is the function of Layer 2 Switch?
Answers were Sorted based on User's Feedback
Answer / kapilasdhir
Layer 2 switch provides the connectivity within a single
Network ID in the Network. There are two types of Layer 2
Switch
| Is This Answer Correct ? | 24 Yes | 8 No |
Answer / channuyadav
layer 2 is the three type function includes the 1)address
learning 2)loop avoidance 3)forword&filtering
| Is This Answer Correct ? | 8 Yes | 1 No |
Answer / parvez
Layer 2 switch supports Mac address and we cannot implement routing process on it. The series of this layer 2 starts from 700 to 3500.
| Is This Answer Correct ? | 7 Yes | 3 No |
How can an Ethernet switch improve network performance? Choose three
How many fillers we can put in one ip of ipv6?
What is the working of router?
What is Data, management, native, default,trunk and access vlan?
What is the link state routing protocol in the TCP/IP protocol stack? A. IP B. IS-IS C. NLSP D. OSPF E. RIP version 2
Why would you use static routing instead of dynamic routing? A.) When you want automatic updates of the routing tables B.) All the time C.) When you have very few routes and want to conserve bandwidth D.) When you have a gateway of last resort
Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department
Which protocol comes under hybrid dynamic type?
Given the command 'cl?', what will it display? A.) Syntax of the 'clock' command B.) Syntax of the 'clear' command C.) All commands that begin with 'cl' D.) All commands that begin with 'c'
Which command will enable CHAP authentication on a serial interface that is using PPP? A.) encapsulation chap B.) ppp chap C.) ppp enable chap D.) ppp encapsulation chap E.) ppp authentication chap F.) ppp chap enable
What is the default bandwidth of a serial connection? A.) 1200 baud B.) 1.544 Mbps (T1) C.) 10 Mbps D.) 96Kpbs
The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'