Answer / moparthynani

A. Deploy RADIUSor LDAP to assign the address to the user.

B. Use DHCP to assign addres based on incoming user policies.

C. Deploy a client model to assign a unique address to the user.

D. Use an internal address pool per VPN headend; use with
ACLs and a static route to the VPN headend.

Answer / gopinath

use an internal address pool per vpn headend; use with
acls and a ststic route to the vpn headend.

or otherwise create the ipsec vpn tunnel between the two
ends.

when ever we apply show flash comand on the router it givesthat informatin router#show flash syatem file directory: file length name/status 1 8121000 c2500-js-L.112-18.bin what does it nean plz help i have read it from book but not bale to understand i am looking towards u for the help

1 Answers   IBM,

---

What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay

1 Answers  

---

What would you include in your prototype design for this particular case study?

1 Answers  

---

When designing a flat switched network you can have: A. the same number of IP and IPX nodes without performance degradation B. more IP than IPX nodes on the same segment C. more IPX than IP nodes on the same segment D. more AppleTalk than IP nodes on the same segment

1 Answers  

---

Which two statements correctly identify considerations to take into account when deciding on campus QoS Design elements ?

1 Answers   Pari Networks,

---

Match the following services with the correct descriptions: A. BRI 1. Provides two 64 Kbps B channels B. PRI 2. Provides 23 or 30 B channels 3. Provides one 16 Kbps D channel 4. Provides one 64 Kbps D channel 5. Provides a total bit rate of 2.048 Mbps in Europe and Australia 6. Provides a total bit rate of 144 Kbps 7. Provides a total bit rate of 1.544 Kbps in North America and Japan

1 Answers  

---

Regarding a full-mesh network and a partial-mesh network, what is the most accurate statement? A. Split Horizon will not work on a full-mesh network B. A full-mesh network is more expensive because more routers are used C. A partial-mesh network is less expensive because less virtual circuits are used D. Broadcasts are more plentiful on a partial-mesh network

1 Answers  

---

Which two LAN switching features apply to store-and-forward switches? A. CRC B. Frame length C. Source address D. Collision Windows

1 Answers  

---

What are two true statements regarding DDR (Dial-on-Demand Routing)? A. Allows a router to automatically initiate and end a circuit-switched session B. DDR cannot be configured because it is set with a default configuration C. Can configure it to be used during non-peak hours D. Can only be used with Cisco PIX

1 Answers  

---

Match the following devices with the correct description. A. Switch 1. Operates at the physical layer and extends the cable as if it is a single cable. B. Router 2. Operates at the physical layer and connects all connections into one device or concentrator. C. Repeater 3. Operates at the network layer and can filter both hardware and network addresses. D. Hub 4. Works at the Data-Link layer and transmits a digital signal only to the specific port where the destination MAC address is located.

1 Answers  

---

What are three ASN.1 (Abstract Syntax Notation One) data types? A. data feeds B. name C. syntax D. encoding

1 Answers  

---

Client traffic is being bridged trough LAN interfaces on two WLCs.Which roaming option will Keep them on the same IP Subnet ?

2 Answers   Pari Networks,

---