Answer / moparthynani

A. Voice need to be assigned to the hardware priority queue.

B. Voice needs to be assigned to the software prority queue.

C. Call singnalling must have guaranteed bandwidth service.

D. Strict-Priority Queuing should be limited to 50 percent
of the capacity of the link.

What are metrics used with IGRP? A. Ticks B. Load C. Hops D. Delay

1 Answers  

---

When doing an RFP (Request for Purchase) for a customer, at what step do you reiterate your solution and the customer requirements? A. Design Requirements B. Design Solution C. Summary D. Appendices

1 Answers  

---

What network design is becoming common when there is a central office with one or more remote locations? A. ISDN PRI at the central location and ISDN BRI at the remote locations. B. Using core routers at all sites C. Only using access routers D. Using a full mesh network

1 Answers  

---

When are SNMP traps sent? A. When the SNMP manager wants to perform remote configuration on a networking device B. When an SNMP agent wants to inform the SNMP manager about a change of state on the networking device C. When the SNMP manager wants to access large chunks of data D. When the NMS wants to share trap information

2 Answers  

---

Which of the following is not true in regards to route summarization? A. It increases the size of the routing table B. It increases the complexity of the network C. IP networks must be contiguous to be safely summarized D. Routing tables must have the capacity to support classless routing

1 Answers  

---

What are three LAPB features supported by SDLC? A. Frame types B. Frame format C. Field functions D. ABM

1 Answers  

---

What is the technique used by a router that can automatically initiate and close a circuit-switched session? A. PLP B. LAPP C. ASN.1 D. DDR

1 Answers  

---

What is the first step in diagramming packet flow for the terminals within a network? A. Identify the end user nodes of all the terminals B. Figure out the speed of all the servers C. Find out where all the routers are located D. Find out where all the switched are located

3 Answers  

---

Which two LAN switching features apply to store-and-forward switches? A. CRC B. Frame length C. Source address D. Collision Windows

1 Answers  

---

Which tools help to characterize a network? A. Sniffer B. CiscoWorks 2000 C. Netsys D. All of the above

1 Answers  

---

What is the standard ethernet cabling specification? (not IEEE 802.3) A. STP B. Coax (thin) C. Coax (thick) D. UTP

1 Answers  

---

It is not necessary to build an entire network to prove your network design. A. True B. False

1 Answers  

---