what is the concept of subnetting and why its used and where it is used?

what is the concept of subnetting and why its used and
where it is used?

Question Posted / radha_9090

3 Answers
11829 Views
TCS, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

what is the concept of subnetting and why its used and where it is used?..

Answer / pranab bose

sub-netting means we r going to divide a single network to
many different sub network by borrow host bit as a network
bits in subnet mask. after subnetting the default subnet
mask has been increasing.(but have same prefixes)

basically when we have a single network address and we need
more than one network address for security, network
broadcast Strom, load balance, remote sites etc. reason then
we are going for subnetting.

Is This Answer Correct ?

15 Yes

4 No

what is the concept of subnetting and why its used and where it is used?..

Answer / shahid solanki

because of huge network, my office are in desparete
location. so here serial technolgy is required to connect
each other. so i will use router as my required deivce.
so rules of router is that two port of router shuod be in
diffrent subnet, but two directly connected router should be
in same subnet, & no two port of a router should ba same subnet.

ans1:- subnetting is nothing else but manipulating of mask.
ans2:- read above...
ans3:- in huge network, or in WAN

Is This Answer Correct ?

2 Yes

0 No

what is the concept of subnetting and why its used and where it is used?..

Answer / radha_9090

i am only know about subnetting concept is used to connect
more networks from hostaddress using ipaddress and it can
produce more network connection.

Is This Answer Correct ?

11 Yes

10 No

Post New Answer

More Protocols AllOther Interview Questions

what is the ethernet interface?where and when we can use? how to connect hte host systems to target system

1 Answers Sasken,

nowadays which protocol we are using?either tcp or udp?which is more useful?

3 Answers

We measure the performance of a telephone line (4 KHz of bandwidth). When the signal is 20 V, the noise is 6 mV. What is the maximum data rate supported by this telephone line?

3 Answers

What are the generally asked questions for a Person who is attending Network protocol testing L2/L3.

0 Answers DLI, IT Labs, Tech Mahindra,

How to place an interface into trunking mode?

1 Answers Cisco,

hi i have small confusion while configuring ppp at that time routing protocal is need ro not

2 Answers Wipro,

What is SDP? Which signaling protocols use it?

0 Answers Cisco,

how to change mac address of a system ?

17 Answers

Why DNS use both TCP and UDP ports. And for which purpose it uses TCP and UDP.