How to place an interface into trunking mode?

Question Posted / guest

1 Answers
8480 Views
Cisco, I also Faced
E-Mail Answers

How to place an interface into trunking mode?..

Answer / sunilbaglur

the following steps are used

Catalyst_4000(config)# int fa0/1
Catalyst_4000(config-if)# switchport mode trunk
Catalyst_4000(config-if)# exit

Is This Answer Correct ?

11 Yes

1 No

Post New Answer

More Protocols AllOther Interview Questions

What is difference b/w static ip address and dynamic ip address

9 Answers HCL, TCS,

Expand PDF

4 Answers

We measure the performance of a telephone line (4 KHz of bandwidth). When the signal is 20 V, the noise is 6 mV. What is the maximum data rate supported by this telephone line?

3 Answers

What is a wildcard mask, and how is it different from a netmask?

10 Answers Cisco, TCS,

What is the difference between http and https?

0 Answers Aspiring Minds,

how to change mac address of a system ?

17 Answers

where do we use the wild card masking in the routing protocols?

2 Answers SAIC,

pls tell me briefly about APIPA

5 Answers

If all stations tries to communicate at same time, what will happen ?

4 Answers Honeywell,

What is IIOP used for?

1 Answers

what is a protocol?

9 Answers

FTP?

9 Answers BFL,

For more Protocols AllOther Interview Questions Click Here