Explain the difference between routing and routed protocols?
No Answer is Posted For this Question
Be the First to Post Answer
What is mac address size of ipv6?
R1#sh ip nat translations Pro Inside global Inside local Outside local Outside global icmp 15.1.1.1:11 10.1.1.1:11 30.1.1.1:11 30.1.1.1:11 icmp 15.1.1.1:12 10.1.1.1:12 20.1.1.1:12 20.1.1.1:12 icmp 15.1.1.1:13 10.1.1.1:13 21.1.1.1:13 21.1.1.1:13 icmp 15.1.1.1:14 10.1.1.1:14 31.1.1.1:14 31.1.1.1:14 R1# So my question is that after every ip address [:] is used & some number. 15.1.1.1{:11}... what is this colon & number indicate. Can anyone tel me this..!!! Thanking you advance. Shahin
What is raid in ccna?
what are layer hierarchy of cisco
Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp
1>What do you mean by Networks and Networking? 2>Difference between Vlan And Sub Interface Vlan? 3>What is Fiber Optic Media Converter? 4>What is Firewall? 5>Difference Between Layer2 and Layer3 Switch? 6>What is the function of Multilayer Switch? 7>Expalin STP? What is the Difference between STP and MST? 8>What is the Function of VTP?Explain the modes of VTP? 9>What kind of Message VTp will Send? 10>What is the Difference between Normal and Manageable Switch? 11>Difference between Local Vlan and End to End Vlan? 12>Difference between Distance Vector and Link State Routing protocol? 13>What do you mean by Backbone Fast Port? 14>what is Root Guard and BPDU Guard?
Can you explain the basic of encryption in VPN?
Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction
What is ping used for?
What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place
Identify the protocol to test connectivity without configuring any layer 3 protocols? A.) TCP B.) Ping C.) IP D.) CDP E.) Telnet
When configuring the subnet mask for an IP address, which formats can be used?A. dotted-decimal. B. Hexadecimal C. Bit-count D. Octal E. Binary