Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the command to configure the configuration-register?
A.) Router# config-register 0x2102
B.) Router(config)# config-register 0x2102
C.) Router(config-reg)# 0x2102
D.) Router> config-register 0x2102
- 2 Answers
- 6246 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
how to find network ID from IP address?without using network calc...
12 Answers Idea, Karbon, NIIT,
Given an IP host address of 172.16.2.160 and a shored mask of 255.255.255.192 to which shored does the host belong? A. 172.16.2.32 B. 172.16.2.64 C. 172.16.2.96 D. 172.16.2.128 E. 172.16.2.192
Identify 2 PPP characteristics? A.) Is proprietary to Cisco B.) Supports authentication C.) Support compression D.) Run on a multi-access network
The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'
Explain why ip address called logical address?
What is the UDP datagram format? A. Source Port - 16 bits, Destination Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data B. Destination Port - 16 bits, Source Port - 16 bits, Length - 16 Bits, Checksum - 16 bits, Data C. Source Port - 16 bits, Destination Port - 16 bits, Checksum - 16 Bits, Length - 16 bits, Data D. Source Port - 8 bits, Destination Port - 8 bits, Length -8 Bits, Checksum - 8 bits, Data
Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in
What is Transport and Tunnel mode?
Explain how many maximum paths you can give on latest ios in rip?
There is a process in Frame-Relay where LMI resolves an IP address from a DLCI number. What is this called? A.) arp B.) inverse arp C.) rarp D.) automap E.) reverse arp F.) arp
Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two commmands should you use to show the routers that are reachable? (Choose two) A. show ip map B. show ip router C. show frame-relay map D. debug frame-relay map
switch kitne volt per work karta hai. what is frame realy. what is isdn and pri and bri.
CCNA 
