When you cords an IP address on a place router which command stale the IP processing on the interface? A. ip enable B. network ip-address C. ip address ip-address subnet mask D. the exit command from the enabled configuration E. copy running-configuration to startup-configuration

3 Answers  

---

Identify the 2 commands that save the running-config to a TFTP server? A.) write running tftp B.) copy running network C.) copy running tftp D.) write network

1 Answers  

---

What is difference between switch & hub?

0 Answers  

---

If a router uses dynamic routing, how does it learn the route to remote networks? The router uses a DHCP request to obtain remote network numbers. The router uses a routing protocol to exchange routing info. with other routers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.

1 Answers  

---

Which layer hides details of network dependent information from the higher layers by providing transparent data transfer? A.) Transport B.) Physical C.) Data Link D.) Session E.) Application F.) Network

5 Answers  

---

Which command specifies a second subinterface on serial interface 0? A. interface s 0.2 point-to-point B. interface 2 s.0 point-to-point C. suberinterface 2.s 0 point-to-point D. interface s 0 sub 2 point-to-point E. interface s 0.1 point-to-point sub 2

2 Answers  

---

In Novell's use of RIP, there are two metrics used to make routing decisions. Select the two metrics. A. Ticks. B. Hops C. Loops D. Counts

3 Answers  

---

What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

2 Answers  

---

How much hold down time of eigrep protocol?

0 Answers  

---

Which term describes the process in which frames from one network system are placed inside the frames of another network system? A. bridging B. tunnelling C. data link control D. generic routing E. packet switching

1 Answers  

---

If i had 400 computers set in a site how many VLAN i should configure so that i can share a proper bandwith,and also i had two lease line connection of 2Mbps each,

1 Answers   IBM,

---

I received a call from client that network is down. We have 100 or 1000 of switches and routers so how could we find the client switch and its port number? and useful commands to find this ?

8 Answers   Cubicor, HCL,

---