Answer / Vimlesh

An IP address consists of 32 bits (4 bytes) when using IPv4 and 128 bits (16 bytes) when using IPv6.

How do you configure a Cisco router to route IPX?

1 Answers  

---

Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department

2 Answers  

---

Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  

---

Where is the point between the customers site and the phone carrier that responsibility changes? A.) CO B.) Demarc C.) DCE D.) DTE E.) CPE

1 Answers  

---

please name some routed protocol.

1 Answers  

---

Which layer is responsible for routing through an internetwork? A.) Physical B.) Session C.) Network D.) Transport E.) Application F.) Data Link

4 Answers  

---

Which layer defines the physical topology? A.) Application B.) Transport C.) Network D.) Data Link E.) Physical F.) Session

1 Answers  

---

Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25

1 Answers  

---

What is default time of hello packets in ospf?

1 Answers  

---

What command can you type to view the connections after telneting into multiple routers simultaneously? A.) sh users B.) sh ports C.) sh host D.) sh sessions

1 Answers  

---

ccna syallabus and what is the mean by troubble shooting

2 Answers   IBM,

---

Can you explain VPN tunneled packet in detail?

1 Answers   CCIE,

---