Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

Tell me CCNA Course + Dump Q/A in chennai?

2 Answers   Microsoft, Wipro,

---

On which layer does L2F, PPTP and L2TP operate?

0 Answers   CCIE,

---

You are given the following address: 15.16.193.6/21. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.248.0, A, 15.16.192.0, 15.16.199.255 B. 255.255.248.0, B, 15.16.192.0, 15.16.199.255 C. 255.255.248.0, A, 15.16.199.255, 14.15.192.0 D. 255.255.242.0, A, 15.16.192.0, 15.16.199.255

2 Answers  

---

8. When is Frame Tagging used? A. When you install repeaters in your network B. When you install bridges in your network C. When you install routers in your network D. When you use Switches configured with multiple VLANS

5 Answers  

---

What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000

2 Answers  

---

what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?

0 Answers  

---

Which command we give for live view of remote site routers?

0 Answers  

---

what is flow control,.

4 Answers  

---

What does the IPX maximum path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

Which of the following is used to manage and monitor the network? A.) SNMP B.) HTTP C.) IP D.) FTP

4 Answers  

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---